BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 47 / 434

Section 03 ENGINE
Subsection 04 (REWIND STARTER)
1
R400motr224A
TYPICAL
1. Apply Molykote PG 54 in spring area
NOTICE
The use of standard multipurpose
grease could result in rewind starter malfunc-
tion.
To install a new rope no. 5 , insert rope into sheave
orifice and lock it with the key no. 4 as illustrated.
R400motr225A
2 1
A
B
TYPICAL
1. Punch
2. Key
A. Maximum 14 mm (.55 in)
B. Rope overstand 20 to 25 mm (.787 to .984 in)
To Adjust Rope Tension:
Wind rope on sheave and place rope sheave into
starter housing making sure that the sheave hub
notch engages in the rewind spring hook.

WARNING
To prevent spring from flying out of the
guide, it is mandatory to secure rope sheave
in place. Always handle with care and use
safety goggles and hand gloves.
Position pawl no. 7 , pawl lock no. 8 and locking
spring washer no. 9 .
Install locking spring no. 10 .
1
R400motr227A
2 3 4
TYPICAL
1. Locking spring
2. Pawl
3. Pawl lock
4. Locking spring washer
Install washer no. 11 and torque screw no. 12 .
1
R400motr229A
2
1. Washer
2. Screw
Rotate rope sheave clockwise until rope end is
accessible through starter housing orifice.
Pull rope out of the starter housing and temporarily
hold it.
NOTE: It is recommended to use a hose clamp to
fix rope in place. A knot can get too tight.
42
vmr2008-123