BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 392 / 434

Section 08 CHASSIS
Subsection 05 (BRAKES)
CAUTION: Do not let caliper hangs by the hose
and do not stretch or twist the hose. Simply
hang it with a piece of wire to take the weight
off the brake hose.
Drain brake system. Refer to
BRAKE FLUID
DRAINING
in this section.
Remove the Banjo fitting securing brake hose to
caliper.
CAUTION: When hoses are disconnected,
cleanliness must be observed. Clean all parts
before disassembly.
Discard sealing washers.
Remove caliper screws.
vmr2008-148-006_a
FRONT CALIPER
1. Caliper screw
2
V07K0ZA
1
REAR CALIPER
1. Banjo fitting and sealing washers
2. Caliper screws
Catch spilled fluid with a rag.
Caliper Inspection (Front and Rear)
Check piston for:
– Rust
– Scratches
– Leaks.
Replace caliper if necessary.
Caliper Installation (Front and Rear)
For the installation, reverse the removal proce-
dure, pay attention to the following details.
Use two NEW sealing washers when installing
Banjo fitting retaining brake hose to caliper.
Install caliper in its original position.
Torque screws in accordance with the following
table.
CALIPER SCREWS TORQUE
Front caliper 34 N•m (25 lbf•ft)
Rear caliper 25 N•m (18 lbf•ft)
Fill and bleed the brake system. Refer to
BRAKE
BLEEDING
at the beginning of this section.
Check for leaks and make sure the brakes operate
normally before driving.
BRAKE PADS
Brake Pad Removal
Place vehicle on a firm level surface.
Loosen wheel lug nuts.
Raise vehicle and support it securely.
Remove appropriate wheel.
Loosen pad pins.
vmr2008-148-008_a
1. Pad pins
2. Caliper
3. Pad
Remove CALIPER , see procedure above in this
section.
Unscrew pad pins then remove pads.
CAUTION: Do not let the caliper hang by the
hose and do not stretch or twist the hose.
396
vmr2008-148