BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 164 / 434

Section 03 ENGINE
Subsection 11 (GEARBOX/OUTPUT SHAFT)
GENERAL
During assembly/installation, use the torque val-
ues and service products as in the exploded view.

WARNING
Torque wrench tightening specifications
must strictly be adhered to.
Locking devices (e.g.: locking tabs, elastic
stop nuts, self-locking fasteners, etc.) must
be installed or replaced with new ones where
specified. If the efficiency of a locking device
is impaired, it must be renewed.
PROCEDURES
OUTPUT SHAFT
Output Shaft Removal
Remove the engine from the vehicle. Refer to
EN-
GINE REMOVAL/INSTALLATION
section.
Measure output shaft axial clearance prior to re-
move it.
1
R400motr195A
2
1. Output shaft
2. Dial indicator
OUTPUT SHAFT AXIAL CLEARANCE
SERVICE LIMIT 0.30 mm (.012 in)
If the output shaft axial clearance is out of specifi-
cation, crankcase must be split and the bevel gear
must be adjusted. See
GEARBOX ADJUSTMENT
in this section.
CAUTION: If the output shaft must be changed,
always replace the bevel gear shaft at the same
time.
Remove:
– Output shaft bearing cover
– Magneto
cover and rotor (refer to
MAGNETO/STARTER ).
Use a soft hammer to remove output shaft no. 6
from housing.
Remove both O-rings and both bearings from out-
put shaft.
NOTE: Both bearings on output shaft have a tran-
sition fit.
1
R400trans04A
2
1. O-ring
2. Bearing on front side
1
R400trans05A
2
1. O-ring
2. Bearing on rear side
Withdraw thrust washer.
160
vmr2008-130