BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 387 / 434

Section 08 CHASSIS
Subsection 05 (BRAKES)
Pump vacuum pump then loosen bleeder.
Pump until no more air bubbles appear in clear
hose.
Close bleeder.
Operate brake lever or brake pedal (except for CE
models, continue bleeding procedure. Refer to
BRAKE BLEEDING (ADDITIONAL STEPS FOR CE
MODELS)
). If it still feels spongy, bleed system
again.
If necessary, repeat the previous procedures un-
til air bubbles do not appear in hose and lever or
pedal is stiff.
Top up reservoirs to the appropriate level.
Install diaphragms and covers on reservoirs.
Wipe any brake fluid spillage.
Check brakes operation before riding the vehicle.
Manual Bleeding Procedure
Install a clear hose on a bleeder.
Place the other end of hose in a small container
partially filled with clean brake fluid.
Carefully pump the brake lever or the brake pedal
few times and hold it while opening the bleeder.
NOTE: When bleeder is opened, brake fluid flows
out of caliper and the brake lever moves toward
the handlebar or the brake pedal moves down.
Retighten the bleeder, then release brake lever or
brake pedal gradually.
Repeat the procedure until no more air bubbles
appear in hose and lever or pedal is stiff (except for
CE models, continue bleeding procedure. Refer
to
BRAKE BLEEDING (ADDITIONAL STEPS FOR
CE MODELS)
).
Top up reservoirs to the appropriate level.
Install diaphragm and cover on reservoirs.
Wipe any brake fluid spillage.
Check brakes operation carefully before riding the
vehicle.
Brake Bleeding
(Additional Steps for CE Models)
Procedure Using a Vacuum Pump
Install the vacuum/pressure pump on the bleeder
of the brake circuit splitter.
vmr2008-148-017_a
1. Splitter bleeder
2. LH front shock absorber
Pump vacuum pump then loosen bleeder.
Repeat the procedure until no more air bubbles
appear in hose and lever is stiff.
Close bleeder.
NOTE: Do not release brake lever until bleeder has
been closed.
Check brakes operation before riding the vehicle.
Manual Bleeding Procedure
Pump the brake lever again and hold it while open-
ing the bleeder on the brake circuit splitter.
vmr2008-148-017_a
1. Splitter bleeder
2. LH front shock absorber
When lever is down, close the bleeder and release
the brake lever gradually.
Repeat the procedure until no more air bubbles
appear in hose and lever is stiff.
Close bleeder.
NOTE: Do not release brake lever until bleeder has
been closed.
Top up reservoirs to the appropriate level.
Install diaphragm and cover on reservoirs.
Wipe any brake fluid spillage.
Check brakes operation before riding the vehicle.
vmr2008-148
391