BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 17 / 434

Section 01 MAINTENANCE
Subsection 04 (SPECIAL PROCEDURES)
SPECIAL PROCEDURES
SERVICE PRODUCTS
Description Part Number Page
XP-S Lube ............................................................................. 293 600 016 ....................................... 9–10
NOTE: These procedures give a guideline of
things to do if one of these abnormal situations
occur with the vehicle.
TURN OVER
When vehicle is turned over or stays tilted on the
side, put the vehicle back on its wheels, then wait
3 to 5 minutes before starting the engine.
Inspect air filter housing drain tube for oil accumu-
lation, if any oil is found, clean air filter and air filter
housing. Refer to
AIR INTAKE SYSTEM section.
Check oil level and refill if necessary.
Check engine coolant level and refill if necessary.
Start engine and let it run at idle, around 1 minute,
then stop engine. Check oil level immediately.
CAUTION: Stop engine immediately if the LOW
OIL message and check engine indicator light
stay ON.
If the engine oil level is good, check the following:
– Oil filter for contamination. Replace oil filter and
oil.
If the problem is still not resolved, check the fol-
lowing:
– Oil pressure switch for damages. Replace it if
necessary.
– Oil strainer cleanliness and damages. Clean or
replace oil strainer.
– Oil pressure regulator valve stays open in the
crankcase due to contamination (metallic parti-
cles). Clean or replace the valve.
– Valve piston stuck in the oil pump housing. Re-
pair valve piston.
– Oil pump cleanliness and operation. Clean or
replace oil pump if necessary.
ATV IMMERSION
ATV Submerged for a Long Time
(Over One Hour)
Disassemble engine and transmission to clean the
internal parts and check if there is no rust or cor-
rosion on any internal parts. Refer to the specific
ENGINE section.
Drain air filter housing then clean and dry air filter.
Remove muffler and empty it. Let muffler dry
then reinstall it on the vehicle.
Flush fuel tank and refill with new gas.
Lubricate throttle body. Refer to
FUEL SYSTEM
.
Look for water in:
– Brake system (replace brake fluid)
– Differentials (drain oil and check internal parts
for rust or corrosion then refill).
Lubricate all cables. Check if the cables operate
properly.
Spray all metal parts with XP-S Lube (P/N 293 600
016).
Test ride to confirm all is working well (electrical
and mechanical components).
ATV Submerged for a Short Time
(Less than One Hour)
Check if engine oil is contaminated (oil will be
milky). If so, perform the following instructions.
Drain engine oil.
Drain air filter housing then clean and dry air filter.
Look for water in fuel tank, in doubt, flush fuel
tank and refill with new gas.
Drain the CVT housing. Refer to
CONTINUOUS-
LY VARIABLE TRANSMISSION (CVT)
.
Remove the CVT cover then clean and check all
parts of CVT.
Lubricate all cables. Check if the cables operate
properly.
Remove spark plug then crank engine slowly
several times.
Add a small quantity of engine oil in cylinder
(approximately 2 teaspoonfuls). Do not reinstall
spark plug at this moment.
Refill engine at the proper level with the recom-
mended oil. Crank engine several times.
Check condition of spark plug. If spark plug ap-
pears good reinstall it, if not install a new one.
vmr2008-117
9