BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 297 / 434

Section 06 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS, GAUGE AND ACCESSORIES)
Replace multifunction switch if the headlight
switch is defective. Refer to
STEERING SYSTEM
section.
OVERRIDE SWITCH
All Models except 2009 CE
See
HEADLIGHT SWITCH
above to locate the re-
verse override button (switch) on the multifunc-
tion switch.
2009 CE Models
On the 2009 models, the reverse override but-
ton is located in the front of the LH multifunction
switch.
vmr2008-140-500_a
TYPICAL – 2009 MODELS
1. Reverse override button
Override Switch Test
The override switch provides a ground signal to
the ECM which cuts out the reverse speed limiting
function when driving in reverse gear.
To test the override switch, disconnect multi-
function switch connector MG1.
vmr2008-139-002_b
TYPICAL – MULTIFUNCTION SWITCH CONNECTORS
1. Disconnect MG1
2. Disconnect MG2
Using a Fluke 115 multimeter (P/N 529 035
868) set to
, measure the switch resistance
between the following wires.
OVERRIDE SWITCH CONTINUITY TEST
SWITCH
POSITION
MULTIFUNCTION
SWITCH
CONNECTOR (MG1)
RESISTANCE @
20°C (68°F)
Released 0.2 max.
Pushed
Pin 5
(ORANGE
wire)
Pin 6
(WHITE
wire)
Open (OL)
vmr2006-020-066_b
TYPICAL
Replace multifunction switch if override switch is
defective. Refer to
STEERING SYSTEM section.
12-VOLT AUXILIARY POWER
CONNECTOR
The 12-volt auxiliary power outlet allows the instal-
lation of additional accessories.
298
vmr2008-140