BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 311 / 434

Section 06 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS, GAUGE AND ACCESSORIES)
Press the horn button, you should obtain close
to 0
(continuity).
If you do not obtain continuity through the switch
from the horn terminal, carry out the following.
Remove the front steering cover, refer to
BODY
section.
Carry out a continuity test of the horn switch and
wiring, refer to the wiring diagram for details.
Repair or replace switch, wiring or connectors as
applicable.
2009 CE Models
If the horn does not function, disconnect horn con-
nectors.
Test for continuity to ground at the black wire ter-
minal (3-KX1).
Turn on the vehicle power.
While depressing the horn button, test for 12 Vdc
between the horn BEIGE/BLACK wire and chassis
ground.
If you measure a good ground and a good 12 Vdc,
replace the horn.
If you do not measure 12 Vdc, Turn OFF vehicle
power.
Remove the front steering cover.
Disconnect the green multifunction switch con-
nector 3-MG3.
vmr2008-140-501_b
1. Multifunction switch connector 3-MG3 (GREEN)
As you press the horn button, test for continuity
through the horn switch, pins 3 and 4.
Also test for continuity of the harness wiring be-
tween the horn connector and the multifunction
switch connector.
Refer to the
WIRING DIA-
GRAM
for details.
Repair or replace wiring/connectors, or horn as re-
quired.
WINCH
XT Models Only
Test winch using the control switch on the LH han-
dle bar and the remote control in the front service
compartment.
vmo2008-019-046_a
TYPICAL
1. Reel winch cable IN
2. Let winch cable OUT
vmo2008-001-001_a
FRONT SERVICE COMPARTMENT PANEL
1. Winch remote control
312
vmr2008-140