BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 229 / 434

Section 05 FUEL SYSTEM
Subsection 01 (ELECTRONIC FUEL INJECTION)
Enter data into ECM as detailed in
ENTERING THE
COLLECTED INFORMATION INTO THE ECM
be-
low.
2 nd Collecting Method: Collect the
Information from the Vehicle
Remove the faulty ECM.
Install and connect the new ECM.
Record vehicle serial number and model number.
2
3
1
V07M18a
TYPICAL
1. E.I.N. (Engine Identification Number)
2. V.I.N. (Vehicle Identification Number)
3. Model
Record engine serial number.
Enter data into ECM as detailed in
ENTERING THE
COLLECTED INFORMATION INTO THE ECM
be-
low.
Entering the Collected Information
into the ECM
Use B.U.D.S. to enter the recorded data into the
new ECM.
In B.U.D.S., click the Read Data button to read the
new “empty” ECM.
vmr2006-012-100_aen
When you change an ECM you get the following
message.
vmr2006-020-058_a
Click Yes to update the system to acquire the new
ECM and to allow engine starting.
Go to the Vehicle tab and enter the information
you recorded previously.
– Vehicle (V.I.N.) number
– Engine number
NOTE: Do not enter the leading “M”.
– Model number
NOTE: Do not enter leading or trailing 0s (zeros).
– Customer.
Go to the Setting tab.
Reset the Closed Throttle and Idle Actuator .
Refer to
CLOSED THROTTLE RESET
above.
vmr2006-014-084_aen
Click on the Write Data button.
vmr2006-012-100_ben
Reinstall remaining removed parts.
Test run engine.
228
vmr2008-136