BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 298 / 434

Section 06 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS, GAUGE AND ACCESSORIES)
12-Volt Auxiliary Power Connector Test
NOTE: When the auxiliary power connector is to
be used on an accessory, be sure to apply a small
amount of dielectric grease (P/N 293 550 004) to
the connector contacts.
Remove front steering cover, refer to the
BODY
section.
Turn ignition key to ON.
Set engine stop switch to RUN.
Disconnect auxiliary power outlet connector (as
applicable).
vmr2006-020-063_a
TYPICAL – AUXILIARY POWER CONNECTOR
Using a Fluke 115 multimeter (P/N 529 035 868)
set to Vdc, measure the voltage as per following
table.
AUXILIARY POWER CONNECTOR
VOLTAGE TEST
WIRE COLOR VOLTAGE
RED/BLACK BLACK
RED/BLACK Chassis ground
Battery voltage
vmr2006-020-064_a
TYPICAL – AUXILIARY POWER CONNECTOR VOLTAGE TEST
If battery voltage is not read for both tests, check
to see if headlights function.
If headlights do not function, test the following:
– Accessories fuse (F6)
– Accessories relay (R4)
– Wiring/connectors.
If headlights function, test wiring/connections to
accessories fuse (F6).
If battery voltage is read to chassis ground but
not to the BLACK wire, test the wire to ground
continuity. Repair or replace wiring as required.
12-VOLT POWER OUTLET
12-Volt Power Outlet Test
Remove dashboard, refer to the
BODY
section.
Turn ignition key to ON.
Set engine run/stop switch to RUN.
Disconnect the power outlet connectors.
Using a Fluke 115 multimeter (P/N 529 035 868)
set to Vdc, measure the voltage as follows.
12-VOLT POWER OUTLET VOLTAGE TEST
WIRE COLOR VOLTAGE
RED/BLACK BLACK Battery voltage
vmr2006-020-061_a
Ensure to reconnect RED/BLACK wire to positive
terminal.
vmr2008-140
299