BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 106 / 434

Section 03 ENGINE
Subsection 08 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
vmr2008-127-053_a
A. Squareness
One-Way Clutch
Check bearings for excessive play and smooth op-
eration. Replace one-way clutch if necessary.
CAUTION: Be careful not to damage the inside
of one-way clutch during bearing removal.
1
R400motr176A
2
3
1. One-way clutch
2. Bearings
3. Drive pulley sliding sheave side
Measure length of spring sleeve no. 8 and check if
edges on top of the spring sleeve are excessively
worn. If out of specifications, replace both spring
sleeves and springs at the same time.
SPRING SLEEVE LENGTH
SERVICE LIMIT 9 mm (.276 in)
Drive Pulley Assembly
For assembly, reverse the disassembly procedure.
Pay attention to following details.
One-Way Clutch
Apply Isoflex grease Topas NB 52 (P/N 293 550
021) on spring sleeves
no. 8 and their springs then
between one-way clutch bearings.
Sliding Sheave
Install centrifugal lever and both thrust washers.
vmr2006-021-019_a
1. Lock nut
2. Centrifugal lever pivot bolt
3. Centrifugal lever
4. Thrust washers
CAUTION: Centrifugal lever must move easily
after installation.
Governor Cup
Rebuild governor cup with new bearing sleeves,
thrust washers, rollers and slider shoes.
Push in bearing sleeve with an appropriate punch
in the direction of the protruding arrow. Push until
bearing sleeve aligns with the contact surface of
the slider shoe.
CAUTION: Final position of bearing sleeve has
to be flush with the contact surface of the slider
shoes (no protrusion).
102
vmr2008-127