BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 68 / 434

Section 03 ENGINE
Subsection 06 (COOLING SYSTEM)
1
V07C0AA
1. Hose pincher
Remove cooling system bleeder screw from top
of thermostat housing.
vmr2008-125-003_a
1. Bleeder screw
2. Thermostat housing
3. Coolant temperature sensor
With vehicle on a flat and level surface, and the
engine cold, refill the radiator.
When coolant starts to escape from the ther-
mostat housing bleeder port, install the bleeder
screw with its gasket ring and torque to 5 N•m
(44 lbf•
in ).
R400motr237A
1
2
TYPICAL
1. Gasket ring
2. Bleeder screw
Remove hose pincher from radiator coolant return
hose.
Top up radiator coolant and install radiator cap.
Refill coolant tank up to the MIN. level mark and
install the coolant tank cap.
vmo2008-019-013_a
TYPICAL
1. Coolant tank
2. MAX. fill level mark
3. MIN. fill level mark
Run engine until thermostat opens then stop en-
gine.
When engine has completely cooled down,
recheck coolant level in radiator and coolant tank,
top up if necessary. The level in the coolant tank
should be between MIN. and MAX. marks.
NOTE: Coolant concentration (freezing point)
should be checked with an appropriate tester,
or replaced as specified in the
MAINTENANCE
CHART
section.
vmr2008-125
63