Arctic Cat HDX CREW 2017, Руководство по обслуживанию

Страница: 88 / 152

87
CC668
10. Install the front and rear secondary driven shaft
assemblies into the left side of the crankcase making
sure the bearing locating pins are toward the top of
the crankcase and the bearing C-ring is fully seated
in the crankcase.
PR787B
11. Place the oil strainer into position; then secure with
the two screws.
12. Place the oil strainer cap into position making sure
silicone sealant is applied; then secure the cap with
cap screws. Tighten to 10 ft-lb.
Joining Crankcase Halves
1. Apply High-Temp Sealant to the left-side mating
surface smoothing out any build-up or bumps.
2. Lightly oil all bearings and grease all shafts in the
right-side crankcase.
3. Using a plastic mallet, lightly tap the case halves
together until cap screws can be installed.
4. From the right side, install the 8 mm cap screws;
then tighten only until snug.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
5. From the left side, install the remaining 8 mm cap
screws (two inside the case); then tighten only until
snug.
 NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
6. From the left side, install the case half 6 mm cap
screws; then tighten only until snug.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
7. From the right side, install the 6 mm cap screws;
then tighten only until snug.
 NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
8. In a crisscross/case-to-case pattern, tighten the 8 mm
cap screws (from steps 4-5) until the halves are cor-
rectly joined; then tighten to 20 ft-lb.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
9. In a crisscross/case-to-case pattern, tighten the 6 mm
cap screws (from steps 6-7) to 10 ft-lb.

NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.

AT THIS POINT
After completing center crankcase components, pro-
ceed to Installing Right-Side Components, to Installing
Left-Side Components, and to Installing Top-Side Com-
ponents.