Arctic Cat HDX CREW 2017, Руководство по обслуживанию

Страница: 27 / 152

26
PR087A
1. Center the steering wheel; then using an open-end
wrench to hold the tie rod ends, loosen the right-side
and left-side jam nuts.
UTV-374B
PR792
2. Turn the left-side and right-side tie rods in equal
increments to achieve the proper toe-out; then
tighten the jam nuts to 8 ft-lb.
Front Fascia/Front Bumper
REMOVING
1. Lift the hood and remove the access cover seal; then
remove the push pins securing the front access panel
and remove the panel.
PR890A
2. Remove the cap screws securing the outer fender;
then remove the inner front fenders from both sides
of the vehicle.
3. Remove the cap screws securing the upper front fas-
cia; then remove the cap screws securing the lower
front fascia.
HDX302A
HDX303A
4. Disconnect the both headlight assemblies; then
remove both headlight retaining clips and headlight
adjuster screw from each assembly. Reference mark
then release the headlight harness anchors from the
front bumper.
CAUTION
Always use a wrench to hold the tie rod ends when loos-
ening or tightening the jam nuts or damage to the boots
could occur.