16
CF364A
CD966A
7. Install one of the CVT cover cap screws into the
driven pulley fixed face; then turn the cap screw
clockwise to spread the pulley faces. Remove the V-
belt.
GZ076
GZ085
CHECKING
Use Drive Belt Gauge to identify any abnormal wear.
Measure across the top of the V-belt (in multiple loca-
tions) using a Vernier caliper. Do not squeeze the belt as
doing so may produce an inaccurate measurement. The
V-belt must be at least 35.0 mm at any point.
INSTALLING
1. Place the V-belt into position on the driven pulley
and over the front shaft.
GZ085
NOTE: The arrows on the V-belt should point in
direction of engine rotation (forward).
2. Pinch the V-belt together near its center and slide the
spacer and movable drive face onto the front shaft.
Secure the drive face with a new nut (threads coated
with red Loctite #271). Using an appropriate spanner
wrench, tighten the nut to 162 ft-lb.
CF366
CAUTION
Make sure the movable drive face plate is fully engaged
onto the splines of the clutch shaft before tightening the
nut or false torque readings may occur. This will cause
the assembly to loosen damaging the shaft and clutch
face plate.
Содержание HDX CREW 2017
Страница 1: ...2017 S SERVICE ERVICE MANUAL ANUAL www arcticcat com...
Страница 151: ...150 NOTES...