Arctic Cat HDX CREW 2017, Руководство по обслуживанию

Страница: 129 / 152

128
HDX293
11. Connect the front drive actuator connector to the
main harness; then secure the wires to the frame with
nylon ties.
12. Apply a light coat of multi-purpose grease to the hub
splines; then install the hubs (see Hub in this sec-
tion).
13. Install the wheels and using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb increments to a final
torque of 40 ft-lb (steel wheel), 60 ft-lb (aluminum
wheel w/black nuts), or 80 ft-lb (aluminum wheel w/
chrome nuts).
14. Remove the vehicle from the support stand.
15. Install the belly panel.
Center/Front Propeller
Shaft/Carrier Bearing
Assembly
REMOVING
1. Remove both seats, rear seat base, and both floor-
boards (see Steering/Body/Controls section).
2. Remove the three cap screws securing the rubber
coupler to the front engine drive flange.
HDX361
3. At the front of the center propeller shaft, remove the
six cap screws and six lock nuts securing the center
rubber coupler to both propeller shafts. Note the ori-
entation of the fasteners.
HDX378
4. Remove the center propeller shaft and rubber cou-
pler. Note the orientation of these components for
assembly purposes.

NOTE: To replace the rubber coupler located at
rear of the center propeller shaft, remove the three
remaining cap screws and lock nuts.
HDX394
5. To disengage the front propeller shaft from the dif-
ferential, pull the propeller shaft rearward. Note the
installed location and condition of the rubber boot.
6. Check the condition of the splines at the front of the
shaft for excess wear. Note the O-ring on the splined
end of the shaft. Replace the O-ring if necessary.
HDX379A
7. To replace the carrier bearing assembly, loosen the
two set screws securing the inner race of the carrier
bearing; then slide the bearing off the shaft.

AT THIS POINT
To replace the carrier bearing assembly and/or the front
propeller shaft, remove the two cap screws and lock
nuts securing the carrier bearing assembly to the frame.