ZyXEL Communications SAM1316-22, User Manual

Page: 145 / 464

Chapter 18 IGMP
SAM1316-22 User’s Guide
145
18.4 IGMP Bandwidth Screen
Use this screen to set up bandwidth requirements for multicast channels. To open
this screen, click Advanced Application, IGMP, Bandwidth Setup.
Figure 69 IGMP Bandwidth
The following table describes the labels in this screen.
Table 37 IGMP Bandwidth
LABEL DESCRIPTION
Port Setup Click Port Setup to open the Bandwidth Port Setup screen where
you can set up multicast bandwidth requirements on specified ports
(see
Section 18.4.1 on page 146 ).
Default
Bandwidth Enter the default bandwidth for multicast channels for which you have
not configured bandwidth requirements.
Apply Click Apply to save your changes to the SAM1316-22’s volatile
memory. The SAM1316-22 loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Index Select a unique number for this setting. If you select a number that is
already used, the new setting overwrites the old one when you click
Apply.
Start Multicast IP Enter the beginning of the multicast range.
End Multicast IP Enter the end of the multicast range. For one multicast address, enter
the start of the multicast range again.
Bandwidth Enter the bandwidth requirement for the specified multicast range.