ZyXEL Communications SAM1316-22, User Manual

Page: 95 / 464

Chapter 13 xDSL Port Setup
SAM1316-22 User’s Guide
95
13.6.1 xDSL Port Setting Screen
To open this screen, click Basic Setting, xDSL Port Setup, and then click a
port’s index number.
Figure 45 xDSL Port Setting
The following table describes the labels in this screen.
Table 19 xDSL Port Setting
LABEL DESCRIPTION
Last Page Click this to return to the previous screen.
General Setup
Active
Select this check box to turn on this DSL port.
Customer Info Enter information to identify the subscriber connected to this DSL
port. You can use up to 31 printable ASCII characters (including
spaces and hyphens).
Profile Select a profile of DSL settings (such as the transfer rate, wire pair
and signal to noise ratio settings) to assign to this port. Use the Port
Profile screen to configure port profiles (see
Chapter 14 on page
107 )
Span Alarm
Profile Select an alarm profile to define the thresholds that trigger an alarm
on the port when exceeded. This alarm profile is for the whole span.
This is the entire connection including any SHDSL regenerators that
might be located between the STU-C (SHDSL Termination Unit -
Central) and STU-R (SHDSL Termination Unit - Remote) end points.
An SHDSL regenerator amplifies the SHDSL signal in order to increase
the connection distance. Use the Alarm Profile screen to configure
alarm profiles. (See
Section 14.8 on page 116 ).