ZyXEL Communications SAM1316-22, User Manual

Page: 257 / 464

Chapter 41 Alarm
SAM1316-22 User’s Guide
257
To open this screen, click Alarm, Alarm Port Setup.
Figure 123 Alarm Port Setup
The following table describes the labels in this screen.
Table 98 Alarm Port Setup
LABEL DESCRIPTION
Alarm Status Click Alarm Status to go to a screen that displays the alarms that
are currently in the system (see
Section 41.2 on page 251 ).
Alarm Event
Setup Click Alarm Event Setup to go to a screen where you can configure
the severity level of an alarm(s) and where the system is to send the
alarm(s). See
Section 41.4 on page 253 .
Port This column lists the device’s individual DSL and Ethernet interfaces.
Severity Select an alarm severity level (Critical, Major, Minor or Info) as the
threshold for events on this port that trigger the SAM1316-22 to send
SNMP traps or sys logs. Critical alarms are the most severe, major
alarms are the second most severe, minor alarms are the third most
severe and info alarms are the least severe.
Apply Click Apply to save your changes to the SAM1316-22’s volatile
memory. The SAM1316-22 loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to start configuring the screen again.