ZyXEL Communications SAM1316-22, User Manual

Page: 421 / 464

Chapter 60 Virtual Channel Management
SAM1316-22 User’s Guide
421
This command removes a PAE PVC.
60.8.2 PAE PVC Set Command
Syntax:
ras> shdsl paepvc set <portlist> <vpi> <vci> <DS vcprofile[,US vcprofile]>
<pvid> <priority> [acname <acname>] [srvcname <srvcname>] [hellotime
<hellotime>]
where
This command creates a PPPoA-to-PPPoE PVC to allow communication between
the ATM (CPE) and Ethernet network (BRAS) segments. The PVC is mapped to a
PPPoE session that connects to the specified BRAS.
The following example creates a PPPoA-to-PPPoE PVC (
1/33
) for port
1
. The VLAN
ID is 1, and the IEEE 802.1p priority is 0. This configuration is for the
video
<portlist> =
The port number of the PAE PVC. You can specify a
single DSL port <1>, all DSL ports <*> or a list of DSL
ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<vpi> =
The VPI of the PAE PVC.
<vci> =
The VCI of the PAE PVC.
<DS vcprofile =
Assign a VC profile to use for this channel’s downstream
traffic shaping.
[,US
vcprofile]>
=
Assign a VC profile to use for policing this channel’s
upstream traffic. The SAM1316-22 does not perform
upstream traffic policing if you do not specify an
upstream VC profile.
<pvid> =
1 – 4094; the VLAN Identifier to add to Ethernet frames
that the system routes using this PVC.
<priority> =
Set the IEEE 802.1p priority (0~7) to add to the traffic
that uses this PVC.
<acname> =
This field is optional. Specify the hostname of a remote
access concentrator if there are two access
concentrators (or BRAS) on the network or that you
want to allow PAE translation to the specified access
concentrator.
<srvcname> =
This field is optional. Specify the name of the service
that uses this PVC. This must be a service name that
you configure on the remote access concentrator.
<hellotime> =
0 - 600; specify the timeout, in seconds, for the PPPoE
session. Enter 0 if there is no timeout.