ZyXEL Communications SAM1316-22, User Manual

Page: 326 / 464

Chapter 50 IEEE 802.1Q Tagged VLAN Commands
SAM1316-22 User’s Guide
326
50.4.4 VLAN Set Command
Syntax:
ras> switch vlan set <vid> <portlist>:<F<T|U>|X|N> [<portlist>:<F<T|U>|X>
...][name]
where
This command adds or modifies an entry in the static VLAN table. Use the
switch
vlan show
command to display your configuration. An example of a configuration
is shown next.
50.4.4.1 Modify a Static VLAN Table Example
The following is an example of how to modify a static VLAN table.
<vid> =
The VLAN ID [1 – 4094].
<portlist> =
You can specify a single port: <1>, all ports: <*>, a list
of ports: <1,3,enet1>, you can also include a range of
ports: <1,5,6~8,enet1>.
<F<T|U>| =
The <F> stands for a fixed registrar administration
control flag and registers a <port #> to the static VLAN
table with <vid>.
For a fixed port, you also have to specify <T|U>, the
tag control flag.
<T> has the device add an IEEE 802.1Q tag to frames
going out through this port(s).
<U> has the device send frames out through this
port(s) without an IEEE 802.1Q tag.
|X|N> =
This is the registrar administration control flag.
<X> stands for forbidden and blocks a <port #> from
joining the static VLAN table with <vid>.
<N> stands for normal and confirms registration of the
<port #> to the static VLAN table with <vid>. This is
used in GVRP applications.
[name] =
A name to identify the SVLAN entry.
Figure 155 Modifying the Static VLAN Example
ras> switch vlan set 2000 1:FU
ras> switch vlan set 2001 2:FU