ZyXEL Communications SAM1316-22, User Manual

Page: 38 / 464

Chapter 3 Front Panel
SAM1316-22 User’s Guide
38
3.2 Front Panel Ports
The following table describes the port labels on the front panel.
Each port is discussed further in the following sections.
3.2.1 Console Port
For local management, you can use a computer with terminal emulation software
configured to the following parameters:
• VT100 terminal emulation
• 9600 bps
• No parity, 8 data bits, 1 stop bit
• No flow control
Connect the male 9-pin end of the console cable to the console port of the
SAM1316-22. Connect the female end to a serial port (COM1, COM2 or other COM
port) of your computer.
3.2.2 LAN (Ethernet) Ports
The factory default negotiation settings for the Ethernet ports on the SAM1316-22
are:
• Speed: Auto
• Duplex: Auto
1-16 Green On The DSL link is up.
Off The DSL link is down.
Table 1 LEDs (continued)
LED COLOR STATUS DESCRIPTION
Table 2 Front Panel Ports
LABEL DESCRIPTION
CONSOLE Only connect this port if you want to configure the SAM1316-22 using the
command line interface (CLI) via the console port.
LAN 10/100 Connect these ports to a computer, a hub, an Ethernet switch or router.
USER
Connect the Telco-50 connector to subscribers.