ZyXEL Communications SAM1316-22, User Manual

Page: 352 / 464

Chapter 52 IGMP Commands
SAM1316-22 User’s Guide
352
52.8.1 Multicast VLAN Set Command
Syntax:
ras> switch igmpsnoop mvlan set <vid> <portlist>:<F<T|U>|X>
[<portlist>:<F<T|U>|X> ...] [name]
where
This command creates a multicast VLAN and sets the allowed/blocked port
member(s).
This command is similar to the command to create a regular VLAN. See Section
50.4.4 on page 326 for examples and more information.
52.8.2 Multicast VLAN Delete Command
Syntax:
ras> switch igmpsnoop mvlan delete <vlanlist>
where
<vid> =
The VLAN ID [1 – 4094].
<portlist> =
You can specify a single port: <1>, all ports: <*>, a list
of ports: <1,3,enet1>, you can also include a range of
ports: <1,5,6~8,enet1>.
<F<T|U>| =
The <F> stands for a fixed registrar administration
control flag and registers a <port #> to the static VLAN
table with <vid>.
For a fixed port, you also have to specify <T|U>, the
tag control flag.
<T> has the device add an IEEE 802.1Q tag to frames
going out through this port(s).
<U> has the device send frames out through this
port(s) without an IEEE 802.1Q tag.
|X> =
This is the registrar administration control flag.
<X> stands for forbidden and blocks a <port #> from
joining the static VLAN table with <vid>.
[name] =
A name to identify the SVLAN entry.
<vlanlist> =
You can specify a single VLAN: <1>, all VLAN: <*>, a
list of VLAN: <1,3>, you can also include a range of
VLAN: <1,5,6~8>.