ZyXEL Communications SAM1316-22, User Manual

Page: 54 / 464

Chapter 5 Initial Configuration
SAM1316-22 User’s Guide
54
Note: If you change the IP address of the SAM1316-22, after you click Apply IP
setting , you have to use the new IP address to log into the web configurator
again.
4
If your subscribers use VPI 0 and VCI 33 (the default for all of the DSL ports), go
to step
13 . Otherwise, use the following steps to change the VPI and VCI settings
for all of the DSL ports.
First, you will delete the default virtual channel from all of the DSL ports. (You
cannot edit it). Then, you will configure a new virtual channel for a port and copy
it to the other DSL ports.
Adding another virtual channel without deleting the default virtual channel is not
recommended since you cannot set the new channel to be the port’s super
channel. The super channel can forward frames belonging to multiple VLAN groups
(that are not assigned to other channels). A channel that is not the super channel
can only forward frames with a single VLAN ID (that is configured on that
channel). In this case, the SAM1316-22 drops any frames received from the
subscriber that are tagged with another VLAN ID.
5
In the navigation panel, click Basic Setting, xDSL Port Setup. The xDSL Port
Setup screen appears.
Figure 18 xDSL Port Setup