ZyXEL Communications SAM1316-22, User Manual

Page: 431 / 464

Chapter 61 ACL Commands
SAM1316-22 User’s Guide
431
• Each type of criteria can only be used once in a classifier. For example,
profile
acl set test protocol tcp protocol udp deny
is not allowed. For this
example, you need to create a separate classifier for each protocol and apply
them to the same PVC(s).
The following example creates an ACL rule example named
test
for traffic from
VLAN 10 with a priority level of 2. This rule limits the rate on the classified traffic
to 1000 kbps and changes the priority level to 7.
Figure 267 ACL Profile Set Command Example
61.1.2 ACL Profile Delete Command
Syntax:
ras> switch acl profile delete <name>
where
This command removes the specified ACL profile.
Note: You cannot remove the ACL profile(s) that is currently in use.
61.1.3 ACL Profile Show Map Command
Syntax:
ras> switch acl profile showmap <name>
where
This command displays the DSL port(s) to which the specified ACL profile is
applied.
ras> switch acl profile set test vlan 10 priority 2 rate 1000 rpri 7
<name> =
The name of the ACL profile.
<name> =
The name of the ACL profile.