ZyXEL Communications SAM1316-22, User Manual

Page: 104 / 464

Chapter 13 xDSL Port Setup
SAM1316-22 User’s Guide
104
13.10.1 PPVC Setup Members Screen
Use this screen to add and remove member PVCs.
Note: The member PVCs must be created on the subscriber’s device.
PVID Type a PVID (Port VLAN ID) to assign to untagged frames received on
this PPVC.
Priority Use the drop-down list box to select the priority value (0 to 7) to add
to incoming frames without a (IEEE 802.1p) priority tag.
Add / Modify Click Add / Modify to save PPVC settings for a port.
In order to change a port’s PPVC settings, just select the port from
the Port drop-down list box and then configure the settings you want.
These settings replace the port’s old settings when you click Add /
Modify.
Clicking Add / Modify saves your changes to the SAM1316-22’s
volatile memory.
The SAM1316-22 loses these changes if it is turned off or loses power,
so use the Config Save link on the navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to start configuring the screen again.
Show Port Select the number of a DSL port for which to display PPVC settings (or
display all of them).
Index This field displays the number of the PPVC.
Port This field displays the number of the DSL port on which the PPVC is
configured.
VPI/VCI This field displays the Virtual Path Identifier (VPI) and Virtual Circuit
Identifier (VCI). The VPI and VCI identify a channel on this port. The
SAM1316-22 uses this PVC channel internally. This PVC is not needed
on the subscriber’s device.
Encap This field displays the PPVC’s type of encapsulation (llc or vc).
PVID This is the PVID (Port VLAN ID) assigned to untagged frames or
priority frames (0 VID) received on this channel.
Priority This is the priority value (0 to 7) added to incoming frames without a
(IEEE 802.1p) priority tag.
Members This field displays how many PVCs belong to this PPVC has. Click the
number to open a screen where you can configure the PPVC’s
member PVCs.
Delete Click Delete to remove a PPVC.
Clicking Delete saves your changes to the SAM1316-22’s volatile
memory.
The SAM1316-22 loses these changes if it is turned off or loses power,
so use the Config Save link on the navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Table 22 PPVC Setup (continued)
LABEL DESCRIPTION