ZyXEL Communications SAM1316-22, User Manual

Page: 72 / 464

Chapter 7 System Information
SAM1316-22 User’s Guide
72
The following table describes the labels in this screen.
Table 11 System Info
LABEL DESCRIPTION
System Name This field displays the device's model name.
ZyNOS F/W
Version This field displays the version number of the device’s current firmware
including the date created.
DSL Driver
Version This field displays the Digital Subscriber Line firmware version
number.
DSP Code Version This field displays the Digital Signal Processor firmware version
number. This is the modem code firmware.
Hardware Version This is the version of the physical device hardware. This field may be
blank.
Serial Number This is the individual identification number assigned to the device at
the factory. This field may be blank.
Ethernet Address This field refers to the Ethernet MAC (Media Access Control) address
of the device.
Hardware Monitor
Enable
Select this check box to turn the hardware monitor on or clear it to
turn the hardware monitor off.
Temperature Unit Select C to display all temperature measurements in degrees Celsius.
Select F to display all temperature measurements in degrees
Fahrenheit.
Temperature Each temperature sensor can detect and report the temperature.
Temperature sensor 1 is near the DSL chipset. Temperature sensor 2
is near the central processing unit. Temperature sensor 3 is at the
hardware monitor chip.
Current This shows the current temperature at this sensor.
MAX This field displays the maximum temperature measured at this
sensor.
MIN This field displays the minimum temperature measured at this sensor.
Average This field displays the average temperature measured at this sensor.
Threshold (Low) This field displays the lowest temperature limit at this sensor.
Threshold (Hi) This field displays the highest temperature limit at this sensor.
Status This field displays Normal for temperatures below the threshold and
Over for those above.
Voltage(V) The power supply for each voltage has a sensor that can detect and
report the voltage.
Current This is the current voltage reading.
MAX This field displays the maximum voltage measured at this point.
MIN This field displays the minimum voltage measured at this point.
Average This field displays the average voltage measured at this sensor.
Threshold (Low) This field displays the lowest voltage limit at this sensor.
Threshold (Hi) This field displays the highest voltage limit at this sensor.
Status Normal indicates that the voltage is within an acceptable operating
range at this point; otherwise Abnormal is displayed.