ZyXEL Communications SAM1316-22, User Manual

Page: 146 / 464

Chapter 18 IGMP
SAM1316-22 User’s Guide
146
18.4.1 Bandwidth Port Setup Screen
Use this screen to set up multicast bandwidth requirements for specific ports. To
open this screen, click Advanced Application, IGMP, Bandwidth Setup, Port
Setup.
Figure 70 Bandwidth Port Setup
Apply Click Apply to save the filter settings. The settings then display in the
summary table at the bottom of the screen.
Clicking Apply saves your changes to the SAM1316-22’s volatile
memory. The SAM1316-22 loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring the fields afresh.
This table shows the multicast range settings.
Index This field displays the number that identifies this setting.
Start Multicast IP This field displays the beginning of the multicast range.
End Multicast IP This field displays the end of the multicast range.
Bandwidth This field displays the allowed bandwidth for the specified multicast
range.
Select Select this, and click Delete to remove the setting.
Delete Click this to remove the selected settings.
Select All Click this to select all entries in the table.
Select None Click this to un-select all entries in the table.
Table 37 IGMP Bandwidth (continued)
LABEL DESCRIPTION