
7 - 77
–
+
ELEC
SIGNALING SYSTEM
SIGNALING SYSTEM
INSPECTION STEPS
If the speedometer will not operate, use the following inspection steps.
*1 marked: Refer to “BATTERY INSPECTION AND CHARGING” section in the CHAPTER 3.
NOTE:
• Remove the following parts before inspection.
1) Headlight
• Use the following special tools in this inspection.
Pocket tester:
YU-3112-C/
90890-03112
*1 Check battery.
Recharge or replace.
Check each coupler and wire
connection.
Repair or replace.
Check multi-function display.
Input voltage
Replace wire harness.
Output voltage
Replace multi-function
display.
Check speed sensor.
Replace.
OK
OK
OK
No good
No good
No good
No good
No good
Summary of Contents for WR250F(W)
