Yamaha WR250F(W), Owner'S Service Manual

Page: 196 / 912

2 - 103
SPEC
CABLE ROUTING DIAGRAM
È
Insert the end of the fuel tank breather hose into the hole in the
steering stem.
É
Fasten the throttle cable, hot starter cable and rectifier/regula-
tor lead onto the frame. Locate the clamp end facing the lower
side of the hot starter cable and cut off the tie end.
Ê
Fasten the diode (at the marking), throttle cable and hot starter
cable onto the frame. Locate the clamp end facing toward the
lower right of the frame and with the tie end facing downward.
Ë
Fasten the wire harness, throttle position sensor lead, starter
motor lead and negative battery lead onto the frame. Pass the
clamp through the hole in the stay (air cut-off valve). Locate the
clamp end facing toward the lower side of the frame and cut off
the tie end.
Ì
Fasten the throttle position sensor lead onto the frame. Locate
the clamp end facing toward the lower side of the frame and
cut off the tie end.
Í
Pass the carburetor breather hoses, carburetor overflow hose
and catch tank breather hose between the connecting rod and
cross tube (frame).
Î
Fasten the neutral switch lead and oil hose together with the
plastic locking ties and cut off the tie ends.
Ï
Fasten the neutral switch lead and AC magneto lead onto the
frame. Locate the clamp end facing toward the outside of the
frame and tie end facing toward the rear of the frame.