Back section drive unit (back section bar)
66
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
Pull cable W166/W167 through the recess on the bar cap
and close the cap (4 screws). Make sure that no cables are
pinched.
7. Attach the energy chain (chain connection) to the inside of the
bar (2 screws).
8. Calibrate the back section motor (CAN test center). See
9. Align the bars (see chapter 24.2 on page 265).
10. Attach the pad plate to the seat section bars (see chapter 12.2
on page 40).
11. Attach the pad plate to the back section bars (see
12. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
13. Put on the pad.
14. Update the software (see the software description from the
CAN test center).
TEST
Perform recheck according to IEC 60601-1; perform function test
and final check.
Summary of Contents for TruSystem 7000
