Trumpf TruSystem 7000, Service Manual

Page: 167 / 306

Locking cylinder with hose
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
167
9. Important: the assembly [7] is attached to the cover [6].
Provide a suitable aid (for example a crate or carton) near the
table base so the assembly can be placed on it. The cables
are not long enough for the assembly to be placed on the
floor.
Remove the center cover [6] under the table base (4 screws
with washers) and store it carefully.
10. Using circlip pliers, release the quick connectors on the
assembly (see chapter 23 on page 260 and hydraulics
diagram on page 299).
11. Be sure to note the cable routing.
Unfasten the hydraulic hose from the wheel up to the assembly
and then carefully pull the hose out of the table base.
12. Attention: Firmly grasp the locking cylinder while unscrewing
the screws. Remove the locking cylinder [8] from the table
base [2] (6 screws with washers and nuts).
Assembly The locking cylinder with hose is full when delivered and therefore
does not need to be bled.
1. Note the head and foot arrangement of the locking cylinder in
the table base. The head-end floor locks (lift 25) have two
wrench flats, and the foot-end floor lock (lift 35) has one
wrench flat.
Insert the locking cylinder into the table base and mount (6
screws with washers and nuts).
2. Restore the original cable routing.
Route the hydraulic hose of the locking cylinder in the table
base and reattach. Make sure the hydraulic hose is routed
with a bending radius of more than 35 mm. Finally, check the
cable routing and fastening and make sure that the cable
cannot independently slide or get between moving parts!