Trumpf TruSystem 7000, Service Manual

Page: 126 / 306

Tilt left assembly
126
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
13. Unscrew the tilt left assembly [5] from the mounting plate [12]
(6 screws [11]).
Remove the tilt left assembly [5] from the suspension plate [6]
(4 screws [13] with washers).
Assembly 1. Address the motor (see the software description from the CAN
test center).
2. Insert the tilt left assembly and attach to the mounting plate with
the bearing blocks (6 screws, but do not tighten).
3. Attach the tilt left assembly to the suspension plate (4 screws
with washers, but do not tighten yet).
Tighten the screws for securing the tilt left assembly to the
mounting plate and suspension plate.
5. Install the spiral cable holder of cables W164 and W104 to
the tilt left assembly (2 screws each).
6. Attach the speaker to the suspension plate (from above, 2
screws).
7. Connect the plug and shielded connection of cable W108 to
the tilt left motor (see circuit diagram on page 295).
8. Restore the original cable routing and cable attachment.
10. Attach frame piece 2 to frame piece 1 (2 screws from below).
14.
CAUTION
Risk of injury due to falling assembly!
Grasp the tilt right assembly when unscrewing the screws on
the suspension plate.
4.
CAUTION
Risk of material damage!
Material wear due to improper assembly! The outer
edges [16] of the suspension plate [6] must be parallel to the
outer edges [17] of the tilt left assembly [5].
9.
CAUTION
Risk of material damage!
Check the cable routing and attachment and make sure that
the cable cannot get between moving parts.