Telescopic spindle - Variant 2
96
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
11. Remove the multifunction tool.
12. Remove the toothed wheel.
13. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
14. Lock operating table (brake)
15. Put on the pad.
16. Calibrate the lift motor (CAN test center). See chapter 24.7 on
page 268.
17. Update the software (see the software description from the
CAN test center).
14.10.2
Telescopic spindle - Variant 2
Important: assembly requires serial number. Note chapter 27 on
page 276.
Disassembly
1. Prepare the operating table (see chapter 7 on page 29).
Note: The lifting position cannot be adjusted if the spindle is
defective.
2. Move the additional lift upward so that the main cardan can
be removed (CAN test center).
3. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
4. Remove the table top (see chapter 12.1 on page 38).
5. Loosen the bellows from the mounting plate (adhesive) and
guide downward.
TEST
Perform function test and final check.
CAUTION
Risk of injury due to electric shock!
The battery plugs cannot be disconnected when the
operating table is set in the lowest lifting position. In this case,
work must be done under voltage. Make sure that no
functions (e.g., lift, tilt) are carried out on the operating table.
Summary of Contents for TruSystem 7000
