Operating table with side rail at the joint
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
45
2. Check the sliding disks and replace them if worn or damaged.
3. Pull the sensor cable through the removed parts (sliding disk -
gear box - sliding disk - inner coupling plate).
4. Press the sliding disk against the gear box and mount both
coupling plates on the gear box (each with 3 screws inside
and 1 screw outside). Make sure the sensor cable does not
get pinched.
5. Tap the 3 pins on each of the coupling plates into the gear
box.
Attention, tap the longer pins on the outer coupling plate into
the gear box. The pins must project about 1 cm out of the
coupling plate.
6. Mount the coupling plate on the coding plate (2 screws).
7. Apply a new self-adhesive cover foil to each coupling plate.
Before this, pull the sensor cable through the cover foil on the
inner coupling plate.
The cover foil with perforations is for the outer coupling plate.
Pay attention to the position. The screw on the coupling plate
must be covered.
8. Pull the sensor cable through the cable pass-through.
9. Carefully pull the sensor cable taut and mount the cover plate
with the cable pass-through onto the inner coupling plate
(1 screw).
10. Place the gear box adapter on the gear box (outside) and tap
it carefully with a plastic hammer until the gear box adapter is
flush with the coupling plate.
11. Turn in 2 screws on the gear box adapter.
12. Fasten the side rail to the gear box adapter (1 screw).
13. Use a spirit level to level the coupling point (joint) on the gear
box.
14. Make sure to re-install the motor in its original position.
Align the lugs on the motor flange with the recesses on the
gear box (connection sockets on the motor are on top), rotate
the motor shaft until the feather key lines up with the slot in the
gear box, precisely insert the key into the slot of the motor shaft,
and then slide the motor into the gear box up to the end stop.
15. Tighten the ring nut on the motor and fixate the connection with
screw coating (#4150041) (at least three application points
evenly distributed across the diameter).
16. Attach the leg section drive unit to the seat section bar (see
chapter 13.4 on page 61).
17. Attach the pad plate to the seat section bars (see chapter 12.2
Summary of Contents for TruSystem 7000
