Reset switch
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
227
21.13
Reset switch
Disassembly
1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the cable deflector [1] from the power supply unit [2].
To do this, unscrew the 2 screws [4] at the top of the power
supply unit [2] and loosen the two screws [3] on the column
base. Guide the cable deflector out of the screws [3] on the
column base and remove it.
4. Pull the plug of the reset switch [5] from the power board
(PB1) [6] on the power supply unit.
5. Remove a piece of the cover foil [7] from the column pot [9]
(head end).
6. From the outside, remove the end cap [8] of the reset
switch [10] on the column pot [9] (head end).
7. Be sure to note the cable routing.
Unfasten the connection cable from the reset switch up to the
power supply unit and remove the cable.
8. Remove the reset switch [10] from the column pot [9] (2
screws).
Assembly
1. Mount the reset switch to the column pot (2 screws). The cable
connection faces down.
Summary of Contents for TruSystem 7000
