Trumpf TruSystem 7000, Service Manual

Page: 123 / 306

Tilt right assembly
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
123
13. Unscrew the tilt right assembly [4] from the mounting plate [7]
(6 screws [8]).
Remove the tilt right assembly [4] from the suspension plate [9]
(4 screws [10] with washers).
Assembly 1. Address the motor (see the software description from the CAN
test center).
2. Insert the tilt right assembly and attach to the mounting plate
with the bearing blocks (6 screws, but do not tighten).
3. Attach the tilt right assembly to the suspension plate (4 screws
with washers, but do not tighten yet).
Tighten the screws for securing the tilt right assembly to the
mounting plate and suspension plate.
5. Attach the column controller to the tilt right assembly (1 screw
with washer).
6. Connect the plug and shielded connection of cable W109 to
the tilt right motor (see circuit diagram on page 295).
7. Restore the original cable routing and cable attachment.
9. Attach frame piece 1 to frame piece 2 (3 screws from below).
10. Attach frame piece 1 to the tilt right assembly (2 screws with
washers).
11. Attach the bellows (see chapter 14.3 on page 78).
12. Attach the table top (see chapter 12.1 on page 38).
14.
CAUTION
Risk of injury due to falling assembly!
Grasp the tilt right assembly when unscrewing the screws on
the suspension plate.
4.
CAUTION
Risk of material damage!
Material wear due to improper assembly! The outer
edges [13] of the suspension plate [9] must be parallel to the
outer edges [14] of the tilt right assembly [4].
8.
CAUTION
Risk of material damage!
Check the cable routing and attachment and make sure that
the cable cannot get between moving parts.