Trumpf TruSystem 7000, Service Manual

Page: 192 / 306

Operating table with side rail at the joint
192
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
7. Tap the 3 pins on the outer coupling plate into the gear box.
8. Mount the coupling plate on the coding plate (2 screws).
9. Apply a new self-adhesive cover foil to the outer coupling
plate.
10. Pull the sensor cable through the cable pass-through.
11. Carefully pull the sensor cable taut and mount the cover plate
with the cable pass-through onto the inner coupling plate (1
screw).
12. Mount the drive unit of the leg section (see chapter 13.4 on
page 61).
13. Attach the cover to the center box (see chapter 12.3 on
page 41).
14. Attach the pad plate to the seat section bars (see chapter 12.2
on page 40).
15. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
16. Put on the pad.
20.8.2 Operating table with side rail at the joint
1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the pad plate of the seat section (see chapter 12.2 on
page 40). Important: keep the back section pad plate
attached so that the bar adjustment is retained.
4. Remove the cover from the center box (see chapter 12.3 on
page 41).
5. Remove the drive unit of the leg section (see chapter 13.4 on
page 61).
6. Remove the cover plate [1] from the inner coupling plate [2]
(1 screw).
TEST
Perform recheck according to IEC 60601-1; perform function test
and final check.