Pad plate
40
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
12.2
Pad plate
Disassembly
1. Prepare the operating table (see chapter 7 on page 29).
2. Note attachment position of pad plate!
Remove the pad plate [1] from the bars [2] (6 screws).
The bars are connected to one another through the pad plate
of the seat section and back section. After disassembly of both
pad plates the left bar moves freely, and can be moved
independent of the right bar. Even minimum differences
between the right and left bar can prevent the table
components from locking into the coupling points later. For this
reason the bars have to be aligned again as soon as both pad
plates are removed.
Assembly
1. Align the bars (see chapter 24.2 on page 265). The
adjustment is required only when both pad plates are
removed.
2. Place the pad plate back in its original mounting position.
Place the pad plate onto the bars and install (6 screws).
3. Put on the pad.
TEST
Perform a function test.
Summary of Contents for TruSystem 7000
