Trumpf TruSystem 7000, Service Manual

Page: 265 / 306

Align the bars
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
265
24.2 Align the bars
The bars are connected to one another through the pad plate of the
seat section and back section. After disassembly of both pad plates
the left bar moves freely, and can be moved independent of the
right bar. Even minimum differences between the right and left bar
can prevent the table components from locking into the coupling
points later. For this reason the bars have to be aligned again as
soon as both pad plates are removed. Because of the minimum
permissible tolerance between the right and left bar, the bars must
be adjusted using an adjustment gauge. Adjustment with other tools
or by eyeballing it is insufficient.
Aligning the bars:
1. Lightly fasten the pad plate to the seat section bars, All screws
must be loose.
2. Move the table top longitudinally to the end position at the
head end.
3. Suspend the TS7000 adjustment gauge (#1817764) [1] on
the table top at the foot end (insertion opening [2] for the
extension adapter). The clamps [4] on the adjustment
gauge [1] are located in the lower holders [3] on the table
top.
4. Carefully move the table top longitudinally toward the foot
end until the right bar [5] hits the adjustment gauge [1].
5. Carefully slide the left bar [6] to the mechanical end stop on
the adjustment gauge [1].
6. Tighten the pad plate screws. The position of the bars is set.
7. Install the pad plate on the back section bar.
8. Remove the adjustment gauge.