Emergency adjustment for the lift
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
35
8. Remove the subfloor cover [3] from the table base (4 screws).
9. Unscrew the lift motor assembly [4] from the column base (4
screws with washers).
Note that simply relaxing the toothed belt tension is not
enough; the toothed belt cannot be removed from the pinion
of the lift motor if the lift motor is built in.
10. Pull the lift motor assembly [4] out of the toothed belt [5] and
place it in the column pot. If necessary, move the assembly
back and forth until the toothed belt [5] can be removed from
the pinion.
11. Remove 4 screws from the bearing shell [6] of the telescopic
spindle.
12. Carefully move the toothed belt manually in the
counterclockwise direction until the bearing shell has moved a
bit out of the column.
13. Secure the bearing shell to the floor plate using two M8x60
screws.
14. Using your hand, carefully move the toothed belt [5]
counterclockwise. The table top moves upwards.
The table top has to be moved at least 15 cm upwards when
the column is fixed at the lowest lifting position. Only then are
the battery plugs and spindle attachment accessible.
15. Disconnect the power plug from battery 1 and battery 2 if the
power supply is still connected.
16. Restore the telescopic spindle to its original assembled
position.
a) Remove both screws securing the bearing shell.
b) Carefully move the toothed belt manually in the clockwise
direction until the bearing shell rests on the floor plate.
c) Attach the bearing shell to the floor plate (4 screws).
17. Replace the lift motor assembly (see chapter 15.6 on
18. Install the subfloor cover [3] on the table base (4 screws).
19. Safety note: The operating table is extremely heavy; take extra
care not to strain your back while righting it. A second person
is needed to right the operating table. Clear the floor in front
of the operating table and clean it if necessary. Right the
operating table with the help of a second person.
20. Remove the multifunction tool.
Summary of Contents for TruSystem 7000
