Trumpf TruSystem 7000, Service Manual

Page: 250 / 306

Cable W156 and W158
250
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
9. Unplug cable W156 [8]/W158 [6] from the assembly [5].
10. Unplug the other end of cable W156 [8]/W158 [6] from the
control module [7].
11. Note the cable routing and attachment.
Unfasten cable W156 [8]/W158 [6] from the assembly [5]
up to the control module [7] and remove cable W156/
W158.
Assembly 1. Restore the original cable routing.
Route cable W156/W158 in the table base.
2. Insert the plug of cable W156/W158 into the socket on the
control module (see circuit diagram on page 295).
3. Plug the plugs at the other end of cable W156/W158 into
the sockets of the assembly (see circuit diagram on
page 295).
4. Refasten cable W156/W158 from the assembly up to the
control module.
5. Restore the original cable routing. Check all connections on
the assembly to be sure they are secure.
Carefully insert the cover with the assembly into the table base
and mount it (4 screws with washers).
6. Mount the cover above the control module (4 screws).
7. Safety note: The operating table is extremely heavy; take extra
care not to strain your back while righting it. A second person
is needed to right the operating table. Clear the floor in front
of the operating table and clean it if necessary. Right the
operating table with the help of a second person.
8. Remove the multifunction tool.
9. Remove the toothed wheel.
10. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
11. Lock operating table (brake)
12. Put on the pad.
TEST
Perform recheck according to IEC 60601-1; perform function test
and final check.