Motor controller circuit board
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
57
7. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
8. Put on the pad.
9. Calibrate the tilt sensor (see the software description from the
CAN test center). Only necessary when installing a new motor
controller circuit board.
10. Configure the motor controller (only necessary when installing
a new motor controller circuit board). See the software
description from the CAN test center.
11. Update the software (see the software description from the
CAN test center).
TEST
Perform recheck according to IEC 60601-1; perform function test
and final check.
Summary of Contents for TruSystem 7000
