Trumpf TruSystem 7000, Service Manual

Page: 88 / 306

Toothed belt from the tilt left drive
88
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
c) Lay the bracket (#1814183) [10] on the drive with the
curve lying on the large toothed belt pulley [11]. The
bracket should not lie on the small toothed belt pulley [12]
yet.
d) Press the spring balance [13] into the bracket [10] until the
bracket rests on both pulleys and the brace [14] in the
middle is slightly pressed. Read the force required to do this
from the spring balance. The value must be between 10 N
and 15 N. If necessary, adjust the toothed belt tension with
the M5 [9] clamping screw.
e) Take the bracket from the drive.
f) Tighten the 4 screws [4] on the motor mounting bracket [5].
g) Remove the clamping screw [9] from the motor mounting
bracket [5].
Install the tilt left assembly (see chapter 15.9 on page 125).
4. Attach the bellows (see chapter 14.3 on page 78).
5. Attach the table top (see chapter 12.1 on page 38).
3.
CAUTION
Risk of material damage!
Material wear due to improper assembly! The outer
edges [15] of the suspension plate [17] must be parallel to
the outer edges [16] of the tilt left assembly [3].