Tilt left assembly
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
125
15.9
Tilt left assembly
Important: assembly requires serial number. Note chapter 27 on
Disassembly
1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the table top (see chapter 12.1 on page 38).
4. Remove the bellows (see chapter 14.3 on page 78).
5. Grasp the column cover, remove the holding screw from the
Trendelenburg assembly and guide the cover carefully
downward.
6. Open the column cover at the top and slide it down (see
7. Separate the frame pieces [1]/[2] from one another (2
screws [3] from below).
8. Detach frame piece 2 [2] from the tilt left assembly [5] (2
screws [4] with washers).
9. Disconnect plug and shielded connection of cable W108
from the tilt left motor.
10. Be sure to note the cable routing.
Unfasten the cables from the tilt left assembly.
11. Unscrew the speaker [8] from the suspension plate [6] (from
above, 2 screws [7]) and place them securely on the column.
12. Remove the spiral cable holder [9] of cables W164 and
W104 from the tilt left assembly [5] (2 screws each [10]).
Summary of Contents for TruSystem 7000
