Frame (connection ring)
80
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
Assembly
1. Make sure to re-install the frame in its original position.
Make sure cables W108 and W109 are routed through the
cutout of the frame parts. Position the frame parts on the drive
assemblies and connect to one another (2 screws from
below).
2. Install the frame on the drive assembly (2 screws each with
washers).
3. Attach the metal panel with the column keypad (see
4. Slide the column cover up and close it (see chapter 9 on
page 31).
5. Open the column cover at the bottom to establish the power
supply (see chapter 8 on page 30).
6. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
7. Put on the pad.
TEST
Perform a function test.
Summary of Contents for TruSystem 7000
