Trumpf TruSystem 7000, Service Manual, Page: 20 / 306

Remote control ▸ System ◂ (secured) menu
20
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
1. ▸ Display of HW/SW states ◂
2. ▸ Block RC on Key Error ◂
This function can be used to block remote control if a keyboard
error was determined.
3. ▸ Show Key Error Status ◂
The display shows which key has an error.
4. ▸ Component Test ◂
The menu item delivers a function test for all hardware
components (touch, motion sensor). Do not make any settings
using this menu item.
5. ▸ Motion Sensor Test ◂
Tilt sensor test
6. ▸ Key test FB ◂
The key test function lets you check the functionality of the
individual keys on the remote control, except for the
C
ANCEL
[i30] key. The key functions are not executed. When
the key is pressed, the (hexadecimal) key code is shown on the
display. No key code is shown for the keys that select joints
(L [i24]/R [i25]).
7. ▸ LED test FB ◂
During the remote control LED test, the background illumination
of the individual keys is tested in sequence.
8. ▸ Start Flash update ◂
No function at this time.
Line Meaning
1 Hardware state and software version of the
application
2 Serial number
3 Graphics version
4 Text version
5 Character set version
6 Upper shell software version
7 Boot loader version
8 Software package version
9 Motor controller and communication processor
version (presently without function)
10 Radio module software version