Lift motor assembly
116
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
5. Slide the multifunction tool [1] mounted as a T under the table
base [2].
6. Safety note: The operating table is extremely heavy; take extra
care not to strain your back when turning it on its side. A
second person is needed to turn the operating table on its side.
With the help of another person, lay the operating table over
onto the multifunction tool (side with the column keypad points
down) and set it securely on the star wheel.
After placing the table on its side, do not activate the
hydraulics system to prevent air from seeping into the hydraulic
hoses.
7. Remove the subfloor cover [3] on the table base (4 screws).
8. If necessary perform an emergency adjustment for the lift so
that the parts in the column pot are accessible (see chapter 11
on page 34).
Then disconnect the power plug from battery 1 and battery 2
if the power supply is still connected.
9. Remove the protective cover [5] on the lift motor [6] (unscrew
the 2 screws and carefully pull out the protective cover).
10. Be sure to note the cable routing.
Disconnect plug and shielded connection of cable W107
from the lift motor [6]. Remove the cable ties
11. Loosen the toothed belt tension: The hexagonal screw [3] on
the tensioning device [4] should be almost fully tightened into
the tensioning device.
CAUTION
Risk of injury due to electric shock!
The battery plugs cannot be disconnected when the
operating table is set in the lowest lifting position. In this case,
work must be done under voltage. Make sure that no
functions (e.g., lift, tilt) are carried out on the operating table.
Summary of Contents for TruSystem 7000
