Trumpf TruSystem 7000, Service Manual

Page: 48 / 306

Back section gear box
48
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
Align the lugs on the motor flange with the recesses on the
gear box (connection sockets on the motor are on top), rotate
the motor shaft until the feather key lines up with the slot in the
gear box, precisely insert the key into the slot of the motor shaft,
and then slide the motor into the gear box up to the end stop.
9. Tighten the ring nut on the motor and fixate the connection with
screw coating (#4150041) (at least three application points
evenly distributed across the diameter.)
10. Attach the back section drive unit to the seat section bar (see
chapter 13.6 on page 65).
11. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
12. Calibrate the back section motor (CAN test center). See
chapter 24.4 on page 266.
13. Align the bars (see chapter 24.2 on page 265).
14. Attach the pad plate to the seat section bars (see chapter 12.2
on page 40).
15. Attach the pad plate to the back section bars (see
chapter 12.2 on page 40).
16. Put on the pad.
17. Update the software (see the software description from the
CAN test center).
TEST
Perform function test and final check.