Trendelenburg assembly
118
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
is needed to right the operating table. Clear the floor in front
of the operating table and clean it if necessary. Right the
operating table with the help of a second person.
10. Remove the multifunction tool.
11. Remove the toothed wheel.
12. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
13. Lock operating table (brake)
14. Put on the pad.
15. Calibrate the lift motor (CAN test center). See chapter 24.7 on
page 268.
16. Update the software (see the software description from the
CAN test center).
15.7
Trendelenburg assembly
Important: assembly requires serial number. Note chapter 27 on
page 276.
Disassembly
1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
TEST
Perform recheck according to IEC 60601-1; perform function test
and final check.
CAUTION
Risk of material damage! Handle the power sensor
(cardan) with care.
The power sensor is a sensitive component and can easily break.
Follow these instructions when handling the sensor:
– Do not allow the sensor to touch magnets.
– Do not jolt the sensor (e.g. by knocking off attached parts with a
hammer).
– Always store the sensors for the different drives separately from
one another and make sure there is sufficient space between
them.
– Do not open the sensor or remove it from the cardan.
– Do not allow the sensor to touch e.g. a micrometer screw or
caliper gauge; they might be magnetized.
– Do not twist the plastic parts on the sensor or reposition them in
any way.
Summary of Contents for TruSystem 7000
