Trumpf TruSystem 7000, Service Manual

Page: 239 / 306

Cable W152
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
239
9. Remove the cover [5] over the coupling point [7] on the side
of table base (2 screws).
10. Unplug cable W152 [6] from the coupling point [7].
11. Disconnect the plug at the other end of cable W152 [6] from
the small filter [8] (1A).
12. Note the cable routing and attachment.
Unfasten cable W152 [6] from the filter [8] up to the coupling
point [7] and remove cable W152.
Assembly 1. Restore the original cable routing.
Route cable W152 in the table base.
2. Connect the plug of cable W152 to the small filter (1A - see
circuit diagram on page 295).
3. Plug the plug at the other end of cable W152 into the socket
of the coupling point (see circuit diagram on page 295).
4. Refasten cable W152 from the filter up to the coupling point.
5. Attach the cover over the coupling point on the table base (2
screws).
6. Restore the original cable routing. Check all connections on
the assembly to be sure they are secure.
Carefully insert the cover with the assembly into the table base
and mount it (4 screws with washers).
7. Mount the cover above the control module (4 screws).
8. Safety note: The operating table is extremely heavy; take extra
care not to strain your back while righting it. A second person
is needed to right the operating table. Clear the floor in front
of the operating table and clean it if necessary. Right the
operating table with the help of a second person.
9. Remove the multifunction tool.
10. Remove the toothed wheel.
11. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
12. Lock operating table (brake)
13. Put on the pad.
TEST
Perform recheck according to IEC 60601-1; perform function test
and final check.